So last night I purchased the Hatchbox filament and it arrived today (Thanks Amazon). I just tried to print with it and I ran into the same issue, the funny thing is that the last few times I attempted a print and then later found it air printing, I noticed the filament is being folded over inside the area around the hobbled bolt.

The one thing that it could be but I highly doubt is the fact I lost the heat sinks for the stepper drivers, so they have been running without them. I am going to contact Collin and see if I can get some replacements. If that doesn't fix the issue the only thing left is the Hexagon Hot End which I have been reading online has had issues with the 1.75mm filament not working.

Edit: When I loaded the Hatchbox filament it bubbled out the nozzle making me think they include something in their filament that others don't.