Results 1 to 10 of 22
Thread: Hexagon vs E3D V6
Threaded View
-
09-10-2015, 09:26 PM #13
- Join Date
- Jul 2014
- Posts
- 305
So last night I purchased the Hatchbox filament and it arrived today (Thanks Amazon). I just tried to print with it and I ran into the same issue, the funny thing is that the last few times I attempted a print and then later found it air printing, I noticed the filament is being folded over inside the area around the hobbled bolt.
The one thing that it could be but I highly doubt is the fact I lost the heat sinks for the stepper drivers, so they have been running without them. I am going to contact Collin and see if I can get some replacements. If that doesn't fix the issue the only thing left is the Hexagon Hot End which I have been reading online has had issues with the 1.75mm filament not working.
Edit: When I loaded the Hatchbox filament it bubbled out the nozzle making me think they include something in their filament that others don't.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help