Results 1 to 3 of 3
Thread: odd Holes in print
-
09-02-2015, 04:01 AM #1
- Join Date
- Sep 2015
- Posts
- 2
odd Holes in print
Hi !
I would like to get an advice. I wanted to make with Creatr HS + Simplify3D a nice sculpture print, but
I faced this kind of holes .
DSCN1490b.jpg
I wonder if this is because I should put 3 layers instead of 3 or whether it is the FormFutura filament.
Any idea or experience return is welcome !
-
09-02-2015, 06:51 AM #2
What layer height?
What print speed?
What material?
What temperature?
What infill pattern/percentage?
What amount of solid vertical, horizontal shells?
In general, I would recommend slower print speed and more shells in horizontal and on top.
-
09-02-2015, 07:19 AM #3
- Join Date
- Sep 2015
- Posts
- 2
Thanks !
I don't remember exactly but quite low speed compared to usual and very high quality (0.100 or 0.080). PLA from Form Futura. Temperature was 205 degrees C, I think.
Infill quite low. 10 % around.
Shells : 2 for everything. But I'm printing something else right now with 3 layers for everyting and it does that for certain curves :/ , so it's something else.
I wonder if material or temperature (had other issues with higher temp). Form Futura roll says temp should be 210 to 220.
No one experienced that ?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion