Results 1 to 10 of 83
Thread: Bonded Heat bed for 12"
Threaded View
-
08-27-2015, 03:28 PM #5
- Join Date
- Feb 2015
- Posts
- 211
Well here is my plan of attack for the Z banding.
1. Replace plastic tube Z axis couplers with metal ones.
2. Replace the threaded rod as mine have wobbled since new.
3. Change from a mechanical relay to a SS relay so I can setup PID on the heated bed to hopefully get rid of the up/down movement of the build plate while the heat comes on and off.
4. If none of the above work I will change to Bowden extruder to take the filament pulling up the X carriage out of the equation and replace the heat bed with a bonded aluminum heat bed.
5. If none of those work I will take the electronics and extrusions off the printer and throw away the piece of crap wooden frame and start from scratch.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion