Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
08-20-2015, 11:27 AM #3
- Join Date
- Aug 2015
- Posts
- 10
Great, let me know your thoughts. So far my observations...
Looks like same overall design as the Flashforge Creator pro, but with Creator (1?) Firmware. When I received mine, a belt was off which I thought was broken. I called the phone number in China, but the individual spoke very little English and requested I email tech support.
Reply was very prompt (just time your email with daytime hours in China) and included photos of how to install etc. I then was able to reinstall the belt & spring tensioner without to much of a problem.
Following the instructions (which seem to jump around a bit out of sequence) I was able to make a couple of simple prints including dual color. It prints fine via USB but I was not able to print from the SD card and the printer gives a "SD card read error". After trying everything (other/smaller SD cards, reformatting FAT16, FAT32 etc), I emailed support (they ask for photos to help explain) and they promptly replied that they will send out a new keypad/SD reader board.
All in all, so far so good. They seem very pro customer support and I give their Tech Support an "A" so far. I've attempted to set up Simplify3D to work, but still haven't got it working yet, but it should. I think it's just my inexperience with 3D printers.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help