Results 1 to 2 of 2
Thread: Configuring home locations.
-
08-09-2015, 05:50 PM #1
Configuring home locations.
Hey guys,
I managed to get the firmware flashed and it connected to my laptop.
However I am currently using Repetier and my X directions arent functioning properly, whether I move the X left or right it goes to the right always except a rare occasion after I restart it.
Also, My Y home moves my bed all the way to the back, I tried switching the home from min to max, then 0 and it stays at the very back when homed.
Thanks,
CB
-
08-18-2015, 02:57 AM #2
Check the following :
1/ your endstops are connected and working.
2/ invert the motor if you can't solve it by soft.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help