Results 1 to 5 of 5
Threaded View
-
08-12-2015, 03:34 PM #5
- Join Date
- Jan 2014
- Location
- Oakland, CA
- Posts
- 935
1700 surfaces? Where did you get this thing? If you scanned the original face with the Sense scanner, you should have got one STL mesh forming a solid, not all these little surfaces. Did you use some kind of mesh-to-NURBS command on your STL? Can you combine all these different surfaces into one, perhaps with a Drape command?
Andrew Werby
www.computersculpture.com
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion