Results 1 to 4 of 4
Thread: Configuring Slic3r and Arduino.
Threaded View
-
08-09-2015, 11:01 AM #2
Are you trying to prepare a Marlin firmware build? If so, the Configuring and Compilation section of the Marlin page on the reprap wiki is a good place to start for info on going about it. See http://reprap.org/wiki/Marlin
Configuration of the slic3r slicer would be a separate issue.
EDIT: Ah, I must have misunderstood the question since I'd already pointed you to the wiki in an earlier thread.Last edited by printbus; 08-09-2015 at 12:08 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion