Results 1 to 2 of 2
Thread: Perspex Enclosure Advice Needed
Threaded View
-
08-06-2015, 03:11 PM #1
- Join Date
- Jun 2015
- Posts
- 13
Perspex Enclosure Advice Needed
I want to build a perspex enclosure for my Duplicator i3, and was after a few tips.
I have seen a few built using brackets to attach the sheets to each other, rather then gluing, and was wondering what the advantage/disadvantage of both methods are?
I was also wondering if there was a consensus on where best to place intake and exhaust ports?
And finally if there was an off the shelf kit I could use as a basis of my design (or just buy)?
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help