Results 1 to 10 of 20
Thread: HobbyKing printer
Threaded View
-
08-01-2015, 11:59 PM #7
- Join Date
- May 2015
- Posts
- 39
I think it runs fine after it's setup correctly. My biggest issue was the z steps/mm was set wrong and I had issues for a month until I figured it out. Pretty easy to work on since it's a Mega 2560, ramps 1.4 setup. The nozzle is a low profile but it's not much work to replace it with a E3D V6.
My co workers didn't believe me when I told them I can print a 1 layer wall thickness tube and it will be water tight. It didn't leak with both PLA and ABS.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help