Results 1 to 7 of 7
Threaded View
-
07-30-2015, 06:28 PM #1
- Join Date
- Jul 2015
- Posts
- 26
Filament bunching up around extruder and not sticking to bed
NEW FlashForge Creator Pro Dual
So i was very exited b/c I successfully printed 3 ABS parts with no issues at all. However,
I've been trying since yesterday to get my 4th print with no success. The filament wraps itself
around the extruder and not to the bed. See picture attached. I have checked temperatures with
my digital thermometer and it all comes to temp. Using same filament included with the bundle from FlashForge
that yielded 3 successful prints. Only change was I had to level the bed for a second time since it lost
level, from prying off the three previous prints.
Any help would be greatly appreciated.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion