Just received my Build plate. Tried a small PLA print on it. First thing I noticed, it was a little hard to get level, since you can't really get a good feel with the "paper" method. After awhile a managed to get it relatively level with corner clamps, little high in the middle. Print sticks well, and comes off easy. But unfortunately there seems to be some productions flaws (air bubbles trapped under what seems to be Skateboard grip-tape?) tried to get most off it out by poking holes and trying to press down the tape again. All in all, nice product if you don't have a heated bed. But if you have a heated bed, I would still just stick to glass. Great customer service though, which is a biiiiiiiiig bonus!

Thanks
Ole