Results 1 to 10 of 19
Thread: Extruder Seizing
Threaded View
-
07-25-2015, 08:17 PM #17
- Join Date
- Jul 2014
- Posts
- 305
Thank you for your reply Printbus! I did mean ESteps I was just typing to fast on my break at work
Also, thank you for the link! A lot of the suggestions in your post I have been trying to narrow down on my printer. My main concern was the fact that I was printing just fine, then it started seizing.
So I am going to keep working with things tonight as the wife is out of the house.
Looking through the Configuration.H file, this is what I found. Is this correct and if so what value should I change?Last edited by BLKKROW; 07-25-2015 at 08:37 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion