Results 1 to 10 of 11
Thread: 10" relay clicking in and out
Threaded View
-
07-22-2015, 10:26 AM #3
Check the terminals on the relay board. Make sure the plastic hasnt started to melt or warp, if they havnt then tighten all the terminals. The wires like to get a little loose and when that happens, little archs between the wires and the terminal start to happen. This will cause the terminals and wires to get hot and melt.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help