What support material works best for Ninja-flex?

[huntleybill]

Thank you Jim. I'm afraid I don't understand your instructions. I looked in support material in slic3r and I don't see any support %.

I attached the file I'm having issues with. This is a gasket that fits around a 1/16" thick piece of metal. The gasket is 1/8" thick with a 1/16" space and then another layer 1/8" thick.

For some reason, the print starts building the suppot layer NEXT to the first layer and builds up from there. Don't know why it does that becuse it only needs to fill the 1/6" gap in the middle. Nothing else. I can't figure out how to get the support material to fill just the 1/16" perimeter.

I've tried everything I can think of but no success.