Ok, so i stretched the extruder spring and added a few drops of machine oil to the hotend tube and extruder... And my first (Almost) successful print just finished.
Now, in the past 6 days, i have had 3 successful prints, counting this one. With that, i can't say for sure if that solved the issue, so i will report again after a few more prints.
The only issue was a bit of warping (First time i have ever seen PLA warp). I was printing at 200C... I've heard people say that 200C is hot, but i have also heard people say that for Makerbot Filament 230C is ideal, but then also heard that it isn't.
Going to try lowering to 190C... Hope that fixes it.
http://imgur.com/a/x44Ci