Results 1 to 10 of 16
Threaded View
-
06-25-2015, 03:12 AM #2
- Join Date
- Sep 2014
- Posts
- 19
I would definitely recommend you to change the plunger kit, can happen that the spring wears off over time. So for a temporary solution you can take it out, stretch it a little bit with pliers, clean the drive gear with metal brush put everything back together, spray just a little bit of WD-40 in the hole where you load filament, then load it and start the print it should give you a better result.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help