Results 11 to 20 of 74
Thread: Free build plate!!!!
-
06-10-2015, 02:00 AM #11
- Join Date
- Jun 2015
- Posts
- 34
ok if soofle616 mjolinor and wolfie could pm me a name and address to send to i will get them shipped out in a day or 2
the 300mm x 300mm will take a little longer to make but should only be delayed by a few more days
-
06-10-2015, 07:43 AM #12
- Join Date
- Oct 2014
- Posts
- 314
-
06-10-2015, 11:55 AM #13
- Join Date
- Oct 2014
- Posts
- 441
I have a Flashforge creator pro, Build envelope: 225 x 145 x 150 mm, I would gladly test it out and review. I currently just use the stock built plate with kapton.
-
06-10-2015, 01:01 PM #14
- Join Date
- Jun 2015
- Posts
- 34
sorry i have already shipped a build plate to a user with that same printer. he should have it in a few days maybe you could wait for the results of that and make a decision on whether to buy one
still looking for a couple more printers to try on. if you have a printer not already mentioned please post
-
06-10-2015, 01:24 PM #15
- Join Date
- Jun 2015
- Posts
- 34
i have posted this also in pp3dp.com but the thread was denied
they must think i am unworthy. does anybody here own an "up" 3d printer that wants a free build plate
-
06-11-2015, 11:16 AM #16
- Join Date
- Jun 2015
- Posts
- 2
I wouldn't mind giving it a shot.
Rapide Lite 200 from Rapide3D
The whole bed is 215mm x 215mm, I'm assuming I can nip off the corners of your plate to allow for the small corner screws. If not, accounting for the screws, the bed is 215mm x 202mm.
-
06-11-2015, 01:23 PM #17
- Join Date
- Jun 2015
- Posts
- 34
-
06-11-2015, 01:39 PM #18
- Join Date
- Jun 2015
- Posts
- 2
That'd be great. I'll PM you ...
-
06-13-2015, 06:14 AM #19
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Arrived this morning, cheers.
At the risk of sounding stupid do I print on the sandpaper side or remove the protective sheet and print on the smooth side?
-
06-13-2015, 07:39 AM #20
- Join Date
- Jun 2015
- Posts
- 34
you print on the grainy side, be sure to keep the nozzle close but not touching to avoid filing the tip down.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help