Results 11 to 20 of 21
Thread: 3D Business Cards Printing
-
06-02-2015, 08:01 AM #11
Felt inspired by the thread and finally had some time to make my own business cards
Half printed, half laser cut and engraved.
I printed the frame with frosty white ABS and tried to design it with rails on the sides so I could easily change the ornament on it (the flower and the gears) or the acrylic part inside. The ornament has a support that slides on the rail. Image attached.
3d printed business cards.jpgPrintare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
-
06-02-2015, 03:22 PM #12
is it me or has this thread become somewhere to just advertise your business while pretending to be an actual forum member ?
Nah it's not just me :-)
-
06-02-2015, 03:46 PM #13
-
06-02-2015, 05:39 PM #14
Or 3D print your own business card...
CP3D bizcard.jpg
-
06-02-2015, 11:13 PM #15
You don't mean Car3less, right? (That is who's post you ended up after...)
Is this the same person as in this thread?
https://github.com/fmalpartida?tab=activity
I'm bad with faces. But if it is the same person... She deserves to get cut a lot of slack here!Last edited by Roxy; 06-02-2015 at 11:22 PM.
-
06-03-2015, 06:11 AM #16
oh hell no not car3less - There are a bunch of posters with 1 or 2 posts who say: 'I bought cards from these people'.
And we're expected to believe they're not from the company itself :-)
-
06-03-2015, 08:25 AM #17
thanks I needed them 2 weeks ago for a 3d printing conference in Abu Dhabi, that was canceled in the end. Lucky me, because I had time to print only 2 business cards
No one could see them. So... as there were not too many printed business cards around here I said to share. ))Printare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
-
06-03-2015, 08:33 AM #18
francfalco
what is the size of the letters on the business card?
Roxy
you are very bad at faces. need more pictures of me? :PPrintare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
-
06-04-2015, 01:58 PM #19
[QUOTE=car3less;59629]francfalco
what is the size of the letters on the business card?
smallest letter cap height is about 7mm
That card is the first test - printed at 0.2
I've also printed at 0.06 and slow, remove the noticeable stepping completely, but i'll need a smaller nozzle to get the letter faces any sharper
-
06-07-2015, 06:19 AM #20
they look nice. I tried to print some text with 5mm height, but didn't go so well.
Printare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion