Results 1 to 10 of 25
Threaded View
-
05-30-2015, 02:06 PM #12
I think that GCode is all ok. Can you try disconnecting PronterFace, doing a reset of the board, re-connecting and see if it prints OK? If it does, that will give you a work-around for the next couple of weeks until the problem gets fixed for real. Oh! I also shut down and restart PronterFace but I'm not sure that is really doing anything.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion