Results 1 to 6 of 6
Thread: You can have too much adhesion !
Threaded View
-
05-30-2015, 01:31 AM #5
When I have had similar issues, I would spritz one corner with water. The water releases the glue, and soaks under the edge, you can then lift that edge a bit. Spritz some more and slowly work the scraper under the part. Takes a while, but you end up making progress as you go, so there's not much stress, just patience.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion