Results 1 to 10 of 10
Thread: Sticking too well!
Threaded View
-
05-28-2015, 12:14 PM #3
Even with the glass still warm I have never had any trouble putting the plate in the freezer. And in 5 minutes... Everything comes off clean and easy. The only down side is I get a lot of fog and condensation on the glass. If I'm going to print something else immediately, that kind of delays things because I have to wait for the bed to heat up enough to get rid of the moisture. And then I can finally spray some more hair spray onto the glass.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion