That is a very good point. I used my flatbed scanner to scan all my wood parts when I first bought this & was using that as the guide for the hole patterns & sizes. I just checked it & they match. I also used a dxf file of the i3v 12" scan file that beerdart uploaded to this thread to check to see if this is the same for the 12" & it seems to be. http://3dprintboard.com/showthread.p...ighlight=plate I knew scanning all those wood pieces in would come in handy one day. Thanks for the thought. I could very well have missed that problem before printing it. I am starting to lean towards printing this flat with support as AbuMaia suggested.