Results 1 to 10 of 24
Threaded View
-
04-20-2015, 04:17 PM #24
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
Well, I think I've finally got a part that's close enough fit.
One surface that looked flat is actually sloped. My first cut had a same sized edge overhang all the way around, but the actual part varies continuously with a couple of notches.
All told I spent a good 5 hours and 3 prints. Would be nice if there were a good scanning service.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion