Results 1 to 10 of 27
Threaded View
-
04-14-2015, 01:44 PM #9
- Join Date
- Jan 2015
- Posts
- 68
Layer height was set to .2 and extrusion was set to .3 so i'll drop it down to .18 so hit that 90% of height mark you mentioned. Also the knob is too big due to design of the part, it's not made for the graphical LCD on my 12" i3v it seems.
I've tightened my belts and can't get them any tighter since I'm all the way over in the adjustment slots for the motor bolts. But the belts seem fine to me, I can pluck them like guitar strings. I leveled my X rails to the Y rails last night and leveled the bed nicely.
Outside of tightening belts what else can i adjust (tighten) to remove any slop?
Thanks for all the help, your prints look great!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion