Results 1 to 10 of 27
Threaded View
-
04-14-2015, 08:41 AM #7
- Join Date
- Jan 2015
- Posts
- 68
Tried printing at 200c and the results are below. The knob end up being too large at the base so I can't push it in to go through the options on the LCD display. I also found that my extruder gears have been getting chewed up because somehow it tightened itself. I loosened the bolt and it turns much easier now so I'll have to see how/if it affects the edges in my prints since the bottom and top are not filled in like I would like.
Am I experiencing Z wobble?
Knob_3rd Print_1.jpgKnob_3rd Print_2.jpgKnob_3rd Print_3.jpgLast edited by Carrot_or_Stick; 04-14-2015 at 08:50 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help