Quote Originally Posted by voodoo28 View Post
No, I had it all setup, but when it came time to install the extruder block to the carriage, the probe arm was in the way of the extrduer/carrige mounting hole. I could not get the screw into the hole without removing the servo and arm. Snowball effect...once the extruder was mounted i could not mount the probe arm cuz the hot end was in the way..
I usually take out the two 16mm screws and take the left shelf support off if I need to get at the extruder mounting screw.

Hey! The instructions should probably say to do that, huh?