Quote Originally Posted by kablahz View Post
It was scary but not difficult at all. I used the glass that I had cut for the bed to place the hotend on while it reached temperature. Then grabbed an adjustable wrench and tightened it up. Be careful when tightening the heater block as it is easy to mess up the threads with the wrench supplied. Tightening the nozzle is simple.
did you do the steps in sequence so that the electronics were only hooked to the thremister and the heater or did you come back to this step once you had all the other electronics hooked up? Was you glass already on your bed? I was worried that it would damage the glass or the heater under it if I had the hot end resting on the glass.