Results 1 to 3 of 3
Thread: outlines dont touch
-
04-02-2015, 09:19 PM #1
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
outlines dont touch
Im trying out PETG for the first time. I Set the outer permiters to 5 layers.. but i notice that when its printing the outlines are not touching each other. i assume this is just a extrusion multipler issue.
-
04-02-2015, 10:01 PM #2
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
filament dia setting and extrusion multiplier. your not flowing enough filament for your printer to extrude the expected extrusion width set in the slicer.
-
04-02-2015, 11:23 PM #3
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
hmm but when i did a print.. the finished piece was slightly oversized
if my extrusion multi was too low.. the piece would be slightly smaller.
fila diam is set right.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help