Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 60

Threaded View

  1. 03-27-2015, 04:30 PM #39
    stridera
    stridera is offline
    Student stridera's Avatar
    Join Date
    Feb 2015
    Location
    Silicone Valley, CA
    Posts
    40
    Follow stridera On Twitter
    I haven't even got this one near my hub. It's only been plugged into the raspberry pi which was plugged into the same power strip as the printer.

    When I first plugged it in, Octoprint worked fine and I was able to control the printer. I got it all setup, got the camera going and everything looked good.

    I turned off my printer and turned it back on, which fried the usb port of the rumba and killed the pi.
    Last edited by stridera; 03-28-2015 at 05:05 AM. Reason: Spelling
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules