Results 1 to 10 of 14
Threaded View
-
03-12-2015, 09:51 AM #3
Yeah I've seen a few versions of that type of thing but then my thinking is that I don't need it on the input side as much as I do on the output side. But there's no way to measure the filament diameter coming out of the nozzle.
You'd need a fine camera and algorithms, but I can just bypass all of that by looking at the print and changing the extrusion multiplier or output flow using the LCD knob.
I feel like an home made input measurement sensor isn't the solution as there are a lot of variables at play for what ends up coming out of the nozzle in the end. It would take forever to develop something that had good enough results.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion