Results 1 to 10 of 19
Thread: 3D printed action figures
Threaded View
-
03-09-2015, 02:55 PM #19
- Join Date
- Apr 2014
- Location
- Germany
- Posts
- 12
I recently updated my self portrait figure with the new ball joints I am currently using for all my figures. The new joints have a couple of advantages:
- The figure is easier to assemble.
- All the joints are plug joints meaning there are no more seams at the side of the figure where the joints need to be encased.
- The joints are much sturdier.
I also fused the pelvis and the abs together. While this makes the figure a little bit less articulated it also makes it a lot less wobbly.
In fact it is so sturdy now I was able to make a simple stop motion test with it:
Here are comparison pics between the old and the new figure:
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)