Results 1 to 5 of 5
Thread: Fan for PLA
-
03-03-2015, 04:16 PM #1
- Join Date
- Feb 2015
- Posts
- 371
Fan for PLA
So i want to add a fan to try printing PLA. Just curious if the Fan0 port is controlled by the firmware. That is to say, if I hook up a fan to this will it work for print cooling?
-
03-03-2015, 06:42 PM #2
- Join Date
- Feb 2015
- Posts
- 70
Just an fyi, I am printing PLA without a fan. Not sure what the fan adds, but I know others do use one.
-
03-03-2015, 07:44 PM #3
The fan helps when bridging. Keeps the filament from dropping by cooling it quicker
-
03-03-2015, 08:30 PM #4
- Join Date
- Nov 2014
- Posts
- 522
it also keeps small parts from overheating
-
03-03-2015, 09:42 PM #5
- Join Date
- Feb 2015
- Posts
- 211
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion