Results 1 to 5 of 5
Thread: Stretch marks on my prints
Threaded View
-
01-15-2014, 10:17 PM #4
Odd. I had similar stretch marks (much worse)
It was because my filament was not rolling freely.
Two Reasons;
One: Hobbed Bolt was too tight and fighting and Spool was not freely spinning, it has to be pulled.
Two: Too hot. But my main issue was the spool.
To test, just cut 30cm off and have it loaded without spool.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion