Results 1 to 10 of 16
Thread: i need of help
Threaded View
-
02-23-2015, 04:50 PM #6
- Join Date
- Jan 2014
- Posts
- 462
M92 to set your extruder steps per mm http://reprap.org/wiki/G-code#M92:_S...steps_per_unit. Calibrate as per the reprap wiki guide [url]http://reprap.org/wiki/Calibration#Extrusion[url].
Your initial setting should be based on the type of extruder you have. I have a Wades, set to 711.11 steps per mm for the extruder. A direct drive extruder will have a smaller number.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion