Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2

Threaded View

  1. 02-21-2015, 07:49 PM #2
    sniffle
    sniffle is offline
    Engineer
    Join Date
    Nov 2014
    Posts
    522
    Edit: ... I misunderstood... I print my abs with a cooling fan but i also print inside an eclosure so its warm air with a heated bed of 120 and a extruder temp of 250.

    The fan hasnt caused warping yet and it helps especially on small layers with cooling sufficiently.

    I printed aria the dragon with abs without issue using that setup.
    Last edited by sniffle; 02-21-2015 at 07:59 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules