Results 1 to 10 of 27
Threaded View
-
02-18-2015, 03:42 PM #5
well cutting a diagonal on the end is pretty simple. just need a way of heating about a 10 mm length to about 240 and then getting it out of the thing it was heated in. This stuff sticks to just about everything lol
A cheap hotend with 2mm metal tube might do the job if I could run it off a pc psu. And then sand it to exact diameter
Not sure how I'd get it at the right temp though.
I don't really do electronics.
But there's a market for someone who can !
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help