I figured out what the problem was.
Just a in case anyone runs into something like the above images.
Turns out my issue was three things things.
One was crap in the nozzle. I did 5 cold pulls and got that cleaned up.
The holes were coming from blockages in the nozzle.
The other issue was the bed was slightly loose.
One of the smaller screws that holds the heated bed to the laser cut bed holder had come lose.
I tighted them up and put a drop from a hot glue gun to keep them from vibrating lose again.
I was also trying out 3.0 Shaxon ABS from Frys.
I switched to ABS from Prototype supply and that seemed to print better.