Results 121 to 130 of 232
-
02-07-2015, 11:54 PM #121
-
02-08-2015, 10:05 PM #122
Guys, your suggestions seem to have sorted out my issues, thank you!
-
02-09-2015, 08:53 AM #123
-
02-09-2015, 10:20 AM #124
-
02-09-2015, 10:50 AM #125
-
02-09-2015, 10:55 AM #126
-
02-09-2015, 10:55 AM #127
So.... If I were to get an ATX power supply with enough capacity on the standby 5v line, I could power the pi from it and use the PS-ON signal on the RAMPS board to power the rest of the system off, is that correct?
-
02-09-2015, 11:30 PM #128
-
02-10-2015, 06:12 PM #129
- Join Date
- Jun 2014
- Posts
- 74
Has anyone tried a Rasberry Pi 2 yet with Octoprint? Gotta say I'm really interested in setting up a Pi with Octoprint and would prefer to get the 2 if it doesn't have issues other than no flash camera pics while printing. Definitely intrigued and ready to jump in.
-
02-11-2015, 08:35 AM #130
- Join Date
- Feb 2015
- Posts
- 70
According to http://www.raspberrypi.org/raspberry-pi-2-on-sale/ the pi-2 is completely backwards compatible with the pi-1 . So, in theory, you should be good to go.
Cura slicer issue
09-13-2024, 02:44 AM in 3D Printing Slicer Discussion