Results 1 to 6 of 6
Threaded View
-
02-01-2015, 11:13 AM #1
- Join Date
- Dec 2014
- Posts
- 8
Y axis has gone bad all of a sudden
When I print a test cube now, my y-axis seems to have problems. Any ideas on what could cause this? My belts are tight and I tried increasing the stepper voltage and I get the same result. The x-axis appears ok
View from side (of printer of a test cube). The irregular edge on the right would be at the front of the printer. Rear is similar
View from front of printer [edges are uniform]
Last week, the same filament and same gcode printed fine.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion