Results 1 to 10 of 14
Thread: Ending Gcode
Threaded View
-
01-28-2015, 06:39 PM #5
Don't you add a T0 or T1 to the M104 commands to specify what tool the command applies to?
Last edited by printbus; 01-29-2015 at 01:13 PM.
Don't you add a T0 or T1 to the M104 commands to specify what tool the command applies to?
Last edited by printbus; 01-29-2015 at 01:13 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion