Results 11 to 14 of 14
Thread: Ending Gcode
-
01-28-2015, 03:42 PM #11
S3d uses the script tab under process. If you have two process then you need two end codes.
-
01-28-2015, 03:58 PM #12
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
I have end codes for each process already but only one of the hotends turns off
-
01-28-2015, 04:16 PM #13
Due you have two M104's?
M104 S0 ; turn off extruder
M104 S1; turn off extruder
-
01-28-2015, 06:39 PM #14
Don't you add a T0 or T1 to the M104 commands to specify what tool the command applies to?
Last edited by printbus; 01-29-2015 at 01:13 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion