Results 1 to 10 of 49
Thread: Upgrade Advice
Threaded View
-
01-25-2015, 08:40 PM #5
- Join Date
- Jan 2015
- Posts
- 67
Just checked all the wires and there good from the plus on the motor to connection to the board. I never changed anything with the firmware or anything, Tried the tiny reset button and still nothing. When I power on all the motors are free until I move around one of the axis, once I do that it locks the motor. tested with a led while hooked to the motor and powered on and every single combo (2 leads) powers the led
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion