Results 1 to 10 of 42
Thread: so what causes this?
Threaded View
-
01-20-2015, 07:26 PM #13
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
I found it easy to tension the Y belt, I just used a spring clamp to pull the Y motor to the rear, then tightened the motor mount bolts. The X belt was harder to tension, as there's not much room to get a good pull on the X motor. I've been thinking up a redesign of the X belt idler so one can turn a bolt to adjust the X belt tension.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help