Results 11 to 14 of 14
Thread: Largest item printed on i3v?
-
01-05-2015, 09:44 AM #11
- Join Date
- Jul 2014
- Location
- Ontario, Canada
- Posts
- 257
Done on a 10". It's pretty decent minus the issue i mentioned about the second layer. It took just a little over 5 hours to print, not sure if that is good or bad, but I'm happy with the quality of it. My goal for this new project is that every part is printable on any printer that has a build volume of 8x8x8. There's 3 more of these frames to be printed, and then onto the other parts of the build
-
01-14-2015, 08:00 AM #12
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
-
01-15-2015, 08:42 AM #13
- Join Date
- Jul 2014
- Location
- Ontario, Canada
- Posts
- 257
Awesome print! Was that done in multiple prints? PLA?
While not my biggest prints, here are a few that have come off recently:
-
01-15-2015, 01:11 PM #14
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
The Rubber band gun, was a single print in PLA. has 4 parts to it
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion