Results 1 to 10 of 18
Thread: my smallest print
Threaded View
-
01-05-2014, 03:53 PM #18
PLA sticks fine, if not better on Kapton tape than ABS does for me.
I have a fairly opposite experience, blue painters tape to me, for lack of a better word is crap. Nothing sticks to it, the heat doesn't penetrate it very well from the heatbed.. I prefer to just change my kapton tape every few months and have a very nice clear shiny finish on my objects. If you are after a good finish and are printing raftless, kapton wins hands down for me.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion