Results 1 to 10 of 22
Threaded View
-
12-28-2014, 10:24 PM #1
- Join Date
- Dec 2014
- Posts
- 7
Newb question: Converting G-code to 1-10 VDC analog signal?
Folks,
I am trying to repurpose a meter by meter XY platform into a 3d printer. The existing system uses linear motors driven by servo amps that get a 1-10 VDC control signal. I have seen a Rambo (?) controller board used on the larger delta printer that appears to control stepper amplifiers. Can it also control servo amps?
I do understand that I am building a system upside down with the XY sitting on the bottom and at high speeds the taller objects will sway like a tree. I am working with what I have.
The existing motion controller is an older two axis delta tau system that is controlled via some proprietary serial commands from a older HMI controller.
Any help is appreciated.
Thanks
Larry
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion