Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 09-19-2014, 06:41 PM #1
    Apollo
    Apollo is offline
    Student Apollo's Avatar
    Join Date
    Jul 2014
    Location
    Southern California
    Posts
    16

    Question Two-Up assembly help?

    I've heard people are having problems frying their printboard. I have the red board and Im not sure if i should use the 220v or 110v setting on the PSU. Can anyone help me? Also does it not matter which slot the wires go in for the heated bed, the fan, and both the thermistors?

    Thanks for any help!
    Reply With Quote Reply With Quote
  2. 12-27-2014, 05:34 PM #2
    BruceLawton
    BruceLawton is offline
    Student
    Join Date
    Dec 2014
    Posts
    4
    Did you figure this out yet? California would be 110V. The board is labelled; the bed heater is the connector farthest from the power input corner. The thermistor connectors are also labelled.
    Reply With Quote Reply With Quote
  3. 12-29-2014, 05:52 PM #3
    Apollo
    Apollo is offline
    Student Apollo's Avatar
    Join Date
    Jul 2014
    Location
    Southern California
    Posts
    16
    Yes, I already got it! Thanks for the reply though!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules