Results 1 to 3 of 3
Thread: Test cube problem
Threaded View
-
12-23-2014, 10:31 PM #2
#1, test cubes should always be printed 100% solid. There is no real reason to deviate from this. Most likely those were printed without enough support and the top sagged.
Print a cube at 100% infill, .2mm layer height, 60mm/s feed rate, 100mm/s travel. 235 temp for abs, 200ish for PLA.
Then snap a picture of it.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion