Results 1 to 10 of 23
Threaded View
-
12-16-2014, 07:50 AM #5
Yes I can absolutely reccomend using the mild (blue) loctite on all screws you don't need to adjust on a regular basis (don't use on essentric spacers, extruder hardware, nylock nuts, T nuts, etc.)
If you had any questions on whether or not to apply it on a per screw basis just let us know! (I bet you'll figure it out though)
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion